Manual For A York Diamond 80 Furnace
. 1420 Answers SOURCE: This unit is designed to condense, I suspect that the drain is blocked by some debris. Remove the larger hoses from the burner box and inducer motor and blow into them to clear any debris.
Plug the end of the hose so you don't force water into either the inducer or burner box. Make sure that there is a vent on the drain just as it leaves the furnace cabinet. This will assist the drain to work properly and not cause the condensation to go up in the pressure switch hose. Posted on Jan 04, 2010. 43501 Answers SOURCE: Hi, Check to see if the blower motor is actually getting power to it.You will have to check for power on the heating speed terminal. And the neutral wires.you should have 120v across those two wires. If you have power then the motor is bad.if no power then the heating relay went bad on the circuit board and you will have to replace the circuit board.
York 80 Furnace Troubleshooting
York Diamond 80 Furnace Ignitor
That is a common problem as those relays are often to light and wear out. Just realize that without an electrical meter to trace things through you are really just grabbing at possibilities and not really able to correctly diagnose your problem. Heatman101 Posted on Dec 08, 2010.
The most exquisite alliance of simplicity and performance for avid sailors across the globe, accommodating personal sailing preferences like never before,. Beneteau manuals.
Comments are closed.