• Stihl Weedeater Fs45 Repair Manual
• Stihl Fs45 Repair Manual Free

The 'basic engine 4140' is used to drive a number of power tools: FS 45, 46, 55; FC 55; BG 45, 55, 65, 85; SH 55, 85; HS 45; HL 45. Servicing procedures for specific machine components are described in the handbook 'Machine components 4140'. There are separate handbooks for servicing procedures for standardized parts and assemblies that are installed in several STIHL power tool models ('Standard Repairs, Trouble- shooting', 'Carburetors').

Stihl Weedeater Fs45 Repair Manual

Reference is made to these handbooks in the appropriate chapters in this manual. You should make use of the illustrated parts lists while carrying out repair work. They show the installed positions of the individual components and assemblies. Refer to the latest edition of the relevant parts list to check the part numbers of any replacement parts needed. Parts lists on microfiche and CD-ROM are always more up to date than printed lists. A fault in the machine may have several caus es.

Stihl Fs45 Repair Manual Free

To hel p locate the fault, consult the trouble- shooting charts for all assemblies in the 'Standard Repairs, Troubleshooting' handbook. Refer to the 'Technical information' bulletins for engineering changes which have been introduced since publication of this service manual. Technical information bulletins also supplement the parts list until a revised edition is issued. Special servicing tools mentioned in the descriptions are listed in the last chapter of this m anual. Use the part numbers to identify the tools in the 'STIHL Special Tools' manual. The manual lists all special servicing tools currently available from STIHL. Symbols are included in the text and pictures for greater clarity.

I am driven to work with no one else in the car (not a van). The ride I get from the Chevy dealership is not in a shuttle van. 2008 rx400h lexus.

The meanings are as follows: In the descriptions. = Action to be taken as shown in the illustration (above the text) - = Acti on to be ta ken t hat i s not shown in the illustration (above the text) In the illustrations: = Poin ter = Direction of movement Service manuals and all technical information bulletins describing engineering changes are intended exclusively for the use of STIHL servicing d ealers. They m ust not be passed on to third parties. Servicing and repairs of power tools with shaft (FS, FC, HL) are made considerably easier if the machine is mounted on assembly stand (2) 5910 890 3100 with the aid of clamp (1) 5910 890 8800.

Secure the clamp to the assembly stand with two washers and two M8 nuts. The complete unit can then be swivelled to the best position for the ongoing repair, thus leaving both hands free.